1. Install the Shower Arm
NOTE:
The showerhead with adapter are not provided.
Remove the temporary nipple from the shower ell.
Apply a bead of plumbers putty or other sealant to the back of
the wall flange according to the manufacturer’s instructions.
Place the wall flange onto the long end of the shower arm just
below the threads, as illustrated.
Apply thread sealant tape to the threads of each end of the
shower arm.
Place the shower arm in the shower ell.
Carefully tighten the shower arm to the shower ell with a clean
strap wrench.
Press the wall flange against the finished wall.
Secure the flange to the shower arm by tightening the setscrew.
Remove any excess putty.
Turn on the water and allow water to flow through the shower
arm to flush the system of any debris.
Turn off the water.
Thread the adapter (not provided) onto the showerhead until
hand-tight.
Hand tighten the showerhead (not provided) to the shower arm.
Apply
plumbers
putty.
Shower Ell
Wall Flange
Shower Arm
Showerhead (Not Provided)
Adapter (Not
Provided)
Setscrew
Kohler Co.
3
1046641-2-A
Summary of Contents for K-10124
Page 11: ...1046641 2 A ...
