6
BEFORE YOU GET STARTED
Spread cushioning flat to lay the TV on. This will help to prevent damage.
ASSEMBLY AND INSTALLATION
2. Connect to antenna
a.
Connect an antenna cable (not supplied) via the ‘ANT’ input port at the
back of the TV.
b.
Ensure the antenna cable is also connected to a working antenna, either
via an antenna wall socket in your home, or directly.
Antenna
wall socket
2a
2b
HDMI 4
HDMI 3
HDMI 2
HDMI 1
(ARC)
ANT
USB 2.0
(5V / 500mA)
AUDIO OUT
DIGITAL
AUDIO OUT
R -AUDIO- L
VIDEO
AV
LAN
Antenna cable
(not supplied)
3. Turning TV on
a.
Plug the power cord into a suitable power outlet. The standby will display
a light, showing that the TV is receiving power.
b.
Press the POWER ( ) button (either on your remote control or the lower
side of the back panel on the TV – see
page 8) to turn the TV on. The
standby light will turn off when the TV is on.
TURNING TV OFF
Press the
POWER ( )
button on the remote control to enter standby mode.
To power down the TV completely, unplug the power cord from the power
outlet.
Do not leave your set in standby mode for long periods of time. If you will not
use the TV for a long time, it is recommended to unplug the set from both the
power outlet and aerial.
Standby mode
Red light on
3a
TV on
Red light off
3b
1. Stand assembly
a.
Attach stand to base of TV.
b.
Insert two 22mm screws and use Phillips head screwdriver (not supplied)
to tighten.
c.
Repeat these steps for second stand.
1b
1c
