K13992 Cleveland Open Cup Flash Point Tester
Operation and Instruction Manual
K13992-Manual
-
7-
IP Publication:
IP 36: Flash Point
5.
Deutsche International Norm (DIN)
http://www.din.de
DIN Publication:
DIN 51376: Flash and Fire Points by
Cleveland Open Cup Tester
6.
American National Standards Institute (ANSI)
1819 L Street, NW (between 18th and
19th Streets), 6th floor
W ashington, DC 20036
Tel: 1.202.293.8020
Fax: 1.202.293.9287
ANSI Publication:
ANSI Z-11.6: Flash and Fire Points by
Cleveland Open Cup Method
7.
Federal Test Method (FTM)
FTM Publication:
FTM 791-1103: Flashpoint by Cleveland
Open Cup
FTM 141-4294: Flash and Fire Points
(Cleveland Open Cup)
1.3 Instrument Specifications
Models:
K13992
Electrical
Requirements:
220-240V 50/60Hz
Power:
1250W
Dimensions
(wxdxh,in.(cm)):
10 x 17.5 x 11.5
(25.4 x 44.5 x 29.2)
Net Weight:
20 lbs (9.1kg)
Gross Weight:
30 lbs (13.6kg)
Altitude:
Rated for use below
2000m
Environmental
Conditions:
As per section 1.4.1 of
IEC 61010
2 Safety Information and Warnings
Safety
Considerations.
The
use
of
this
equipment may involve
hazardous
materials and
operations. This manual does not purport to
address all of the safety problems associated with
the use of this equipment. It is the responsibility of
any user of this equipment to investigate,
research, and establish appropriate safety and
health practices and determine the applicability of
regulatory limitations prior to use.
Equipment Modifications and Replacement
Parts.
Any modification or alteration of this
equipment from that of factory specifications is
NOT
recommended because it voids the
manufacturer
warranty,
product
safety,
performance specifications, and/or certifications
whether specified or implied, and may result in
personal injury and/or property loss. Replacement
parts must be O.E.M. exact replacement
equipment.
Unit Design.
This equipment is specifically
designed for use in accordance with the applicable
standard test methods listed in section 1.2 of this
manual. The use of this equipment in accordance
with any other test procedures, or for any other
purpose, is not recommended and may be
extremely hazardous.
Chemical Reagents Information.
Chemicals and
reagents used in performing the test may exhibit
potential hazards. Any user must be familiarized
with the possible dangers before use. We also
recommend consulting the Material Data and
Safety Sheet (MSDS) on each chemical reagent
for additional information. MSDS information can
be
easily
located
on
the
internet
at
http://siri.uvm.edu
or
http://www.sigma-
aldrich.com.
