Koden MDC-5004, Installation Manual

Page: 65 / 156

MDC-5000 Series Chapter 4 Setup after installation
0092653004-00 4-11
4.2 Setup I/O Interface
For display mode, TT(ATA), true ship
’s trail and own ship’s trail, it is necessary to input ship’s bearing
data and ship
’s speed data from other devices. In addition, for AIS, mapping function, display of own
ship
’s information and display of latitude and longitude, it is necessary to input latitude and longitude
data of own ship
’s data. In order to use these data, set the following menu items after connection in
accordance with 3.4
“Cable connection to a Processor unit”.
Note: Refer to
“4.2.2 How to use without NMEA input connection” for the method to use without
inputting NMEA data.
Example display: Press MENU
key to display “Menu” and select [MAINTENANCE] => [I/O]
Figure 4.6 I/O menu
>I/O
HDG
> Select input source of heading
MAN 0.0° Manual input heading data
OFFSET 0.0° Offset value of heading input
STW > Select input source of STW
MAN 6.6kn
Manual input STW data
COG/SOG >
Select input source of COG/SOG
DLOG 218.3°
Talker device name and course value
DLOG 6.6kn
Talker device name and speed value
POSITION > Select input source of position data
DGPS 35°15.174N Talker device name and LAT/LON value
139°48.010E
OFFSET DTM Input device of positon offset data
MAN 0.000N The name of position offset value and offset value
0.000E
SET/DRIFT >
Select input source of SET/DRIFT VDR or MAN
MAN 0.0°
Manual input SET data
0.0kn
Manual input DRIFT data
TIME > Select input source of time ZDA or CLOCK
GPS 01/01/15 Time souce name and date and time
07:57
TIME ZONE TIME ZONE 00:00 Time zone value
OUTPUT >
Setup NMEA sentences of output
INPUT >
Setup NMEA sentences of input
BAUDRATE >
Setup baud rate
KGC SET >
Setup KODEN GPS compass
SERIAL MONITOR > Serial monitor of NMEA data