Koden KGP-922, Operation Manual

Page: 91 / 136

KGP-922 Chapter 5 How to use LOPs
0093130022-00 5-1
Chapter 5 How to use LOPs
5.1 Initial setup for LOPs display
Measured longitude and latitude can be translated into loran C, loran A or DECCA. To turn on the LOPs
mode, the following initial setup is required.
5.1.1 Selecting LOP (Loran C, Loran A or DECCA)
You can select the type to translate from longitude and latitude.
The procedure is as follows:
(1) Press key until Menu options 1 to 10 appears.
(2) Press key to select
“
8: Initial setup
”.
(3) Press key to select
“
8: Lop
”.
In the case
“LoranC”
(4)
Press [ ] or [ ] key to move cursor onto the “LoranC”.
(5) Press key.
(6) Press [ ] key to move cursor onto the
“
9: Chain
”.
(7) Input the station of LoranC by numeric keys.
8/S
MENU
ENT
NOTE: Press to backspace the
cursor to correct an input
error.
NOTE: Press to clear incorrect
Input. You can reenter
Numeric data.
CLR
8/S
When serect Loran C, you must select station
Press
8/S