Koden KGP-922, Operation Manual, Page: 41 / 136

KGP-922 Chapter 2 Various Navigation
0093130022-00 2-15
(5) Press key to display the pop-up.
(6) Select [ Delete ] in the pop-up and press key.
(7) Press key to display the pop-up.
(8) If OK, select [ Yes ] in the pop-up and press key.
If Cancel, select [ No ] in the pop-up and press key.
2.5 Route setup
You can use up to 500 points to go to a final destination using route navigation. You can also reverse
the navigation route to return to the start point. To do so, you must first store the waypoints and route
from MENU 1
. See “
2.1 Storing waypoints (LAT/LONG) data
” (page 2-1).
You can set the route by entering a route number, forward/backward navigation, and start waypoint
number of the route.
2.5.1 Selecting route navigation
You navigate on a route, following the course line, which is automatically updated as you reach each
waypoint. Use the following steps to start route navigation.
Select the reverse navigation only after you have reached the final destination, or the route navigation
may not work properly.
(1) Press key until Menu options 1 to 10 appears.
(2) Press key to select
“
2: Routes
”.
(3) Press key to s
elect “
1: Route Set / Edit
”. Route Input screen is displayed.
(4) Enter a route number (01 to 100) by numeric keys and press key.
(5) Press key to display the pop-up.
ENT
ENT
ENT
ENT
2/N
MENU
1
ENT
Press
ENT
NOTE: To erase all stored data from memory, see
“WPT./Route clear” (page 6-5).
First destination
Direction
Route
number
Press
ENT
ENT
ENT