Kodak X-OMAT 7000, User Manual, Page: 51 / 146

Operating Instructions
7E6174 – 16FEB01 4– 3
3. Press DONE/RETURN until you return to the Processor Main Menu.
Note
The K/RA cycle is not available from this menu. Special chemicals and films are
required. This cycle may only be selected by a Kodak trained Key Operator and a
Kodak Service Representative.
Cycle Information
Changing from STD to RAPID requires approximately 5 minutes for the temperatures
to change and stabilize. From RAPID to STD requires approximately 15 minutes for
the temperatures to reduce.
The cycle will be shown on the Display Panel of the KODAK X-OMAT Multiloader
7000 (Multiloader).
Replenisher rates, speed, and temperatures are automatically adjusted for the chosen
cycle.
Cycle
Process Time
In Seconds
Drop Time In
Seconds Films and Chemicals
Throughput
Films/hour
K/RA USA 48 58 RA Films and RA
Chemicals 270
K/RA
Outside
USA 64 77 RA Films and RA
Chemicals 201
Rapid 64 77 KODAK Films and
KODAK X-OMAT
Chemicals 148
Standard 86 105 KODAK Films and
KODAK X-OMAT
Chemicals 148
Cycle The film processing cycle that is currently selected.
Process Time The time it takes the leading edge of a 35 x 43 cm
(14 x 17 in.) sheet of film to move from the Entrance Rollers
to the Exit Rollers of the Dryer Rack.
Drop Time The time it takes the leading edge of a 35 x 43 cm
(14 x 17 in.) sheet of film, fed 43 cm wide, entering the
Entrance Rollers until the trailing edge exits the Dryer Rack.
Film and Chemicals For optimum image quality use KODAK Films in
combination with KODAK X-OMAT Developers and Fixers
or the equivalent.
NOTE: For the K/RA Cycle, contact your Kodak Service
Representative for film and chemistry recommendations.
Throughput The number of 35 x 43 cm (14 x 17 in.) sheets of film, fed
43 cm wide, that can be processed in 1 hour.