Kodak DirectView CR 500 System, User Manual

Page: 94 / 236

7-2 1F1976 August 1, 2003
Troubleshooting
Releasing Cassette and Phosphor Screen Jams
To release a cassette or phosphor screen from the CR 500 Reader, do the
following:
1.
At the Main Menu select Utility Menu .
2.
Select System Recovery .
3.
Select Release Cassette.
4.
Select Auto Recovery to clear the jam in the system. Remove the
cassette and inspect it for the screen.
5.
If the cassette and screen are released, select Main Menu and resume
normal operation. If the screen does not return, select Auto Recovery
again.
If the screen still does not return:
1.
Remove the louvered (1) door from the back of the Reader and check
for the screen. Remove the screen if possible.
2.
If you cannot remove the screen from the back of the Reader, select
Manual Recovery and wait a few seconds for the rollers to close.
3.
Remove the side panel (2).
CAUTION
:
Be careful when touching internal surfaces. They may be hot!
4.
Turn the
Advance Knob
(5) to move the screen up to the Reader’s rear
opening or turn the other way to expel the screen through the front of
the reader, and remove. If that is not successful, do the following:
5.
Turn the Reader’s power switch to O .
6.
Turn and remove the thumbscrew (4).
7.
Unplug (3) the erase light assembly and remove.
8.
Remove the screen.
9.
Replace the erase light assembly and plug it back in (3).
10.
Replace and turn thumbscrew (4). Replace the side panel.
11.
Turn the Reader’s power switch to I .
12.
After releasing the screen, select Main Menu.