Troubleshooting
October 2020
5-13
6. Remove the used ribbon.
Note: Images remain on the ribbon after printing. If you need to
maintain confidentiality, dispose of the used ribbon
appropriately.
7. Cut off any damaged areas of the ribbon.
8. Overlap the ends of the ribbon.
9. Place tape at the center and at each end of the ribbon.
IMPORTANT:
Slack in the ribbon can cause a paper jam.
10. Wind the repaired end of the ribbon onto the take-up spool.
Make sure that you remove any slack in the ribbon.
11. Move the power switch to the On (
|
) position.
12. Install the ribbon.
See “Loading the Ribbon” on page 2-16
.
Ribbon
Tape
