Kobold NGR, Operating Instructions Manual

Page: 22 / 59

3 Configuring the switching outputs
2 2
3.6 N/O output with error signal
Application
If there is an error message at the NGR , this can be transferred using a
switching contact.
Configuration
■
Configure the Qx switching output as normally open
○
Set the parameter in the
QxMENU-OUx
menu to Qx_Eno
■
Select the electrical property [NPN/PNP/DRV (push/pull)]
○
Select the parameter in the QxMENU-TYPx menu
○
The following information applies:
▫
Qx-PNP = Switching output in PNP circuit
▫
Qx-NPN = Switching output in NPN circuit
▫
Qx-Drv = Switching output in push/pull function
3.7 N/C output with error signal
Application
If there is an error message at the
NGR
, this can be transferred using a
switching contact.
Configuration
■
Configure the Qx switching output as normally closed
○
Set the parameter in the QxMENU-OUx menu to Qx_Enc
■
Select the electrical property [NPN/PNP/DRV (push/pull)]
○
Select the parameter in the QxMENU-TYPx menu
○
The following information applies:
▫
Qx-PNP = Switching output in PNP circuit
▫
Qx-NPN = Switching output in NPN circuit
▫
Qx-Drv = Switching output in push/pull function