KOBELT MANUFACTURING CO. LTD mnl5028-A.docx (rev A)
19
BALANCING LINK ADJUSTMENT
To adjust;
1.
Loosen screws ‘B’,
2. Apply brakes onto the disc,
3.
Ensure link ‘A’ has no tension on it. Adjust if
necessary.
4.
Tighten screws ‘B’
When reinstalling the shoes and pivot blocks reinstall the shoe pin first to align the pivot blocks
before tightening screws ‘C’.
Tighten screws ‘C’ to
37 ft-lbs [50.2 Nm].
5.4
R
ECOMMENDED
S
PARES
The spare parts kept on hand will depend on the severity of the service. As a minimum Kobelt
recommends keeping the following parts for each brake in service:
1.
One Lined set of brake shoes
2.
One set of brake pads with rivets
3.
One actuator
4.
Two seal kits
Refer to the parts list drawings in Appendix B for a complete list of parts.
It is recommended that any required service work on a Kobelt unit be
performed by a factory authorized service representative. Please contact
the nearest Kobelt authorized distributor for assistance.
Summary of Contents for 5028-A
