KOBELT MANUFACTURING CO. LTD MNL-5022-H.docx (rev A)
20
5.4
R
ECOMMENDED
S
PARES
The spare parts kept on hand will depend on the severity of the service. As a minimum Kobelt
recommends keeping the following parts for each brake in service:
1.
One Lined set of brake shoes
2.
One set of brake pads with rivets
3.
One actuator
4.
Two seal kits
Refer to the parts list drawings in Appendix B for a complete list of parts.
It is recommended that any required service work on a Kobelt unit be
performed by a factory authorized service representative. Please contact
the nearest Kobelt authorized distributor for assistance.
The table below itemizes which kit/spare part numbers change with the various brake
configuration options. Please reference this table to ensure you receive the correct parts.
Table 6: Configuration Kit Numbers
Configuration Kit Numbers
Actuator Code
Actuator No.
Description
-H
6112-H
1000 psi
-H1
6204
300 psi
Disc Code
Shim Kit
Disc Thickness
-175
5022-1750
1.750 in
-150
5022-1500
1.500 in
-125
5022-1250
1.250 in
-100
5022-1000
1.000 in
Friction Code
Lined Shoe
Friction Material
-N
5022-LSN4
non-sparking
-C
5022-LSC4
low COF (.12-.15)
-E
5022-LSE4
mid COF (.25-.28)
Summary of Contents for 5022-H
