KoamTac SMARTSLED KDC400 Series, User Manual, Page: 93 / 231

KDC User Manual S
YNCHRONIZATION
93
Select Symbologies and Symbology Options
The process for scanning and reading barcodes is delicate and complicated. Although your
KDC is equipped with a high performance scan engine, if configured incorrectly it may not
perform at its peak performance level. To ensure its high performance, the KDC comes
configured to optimize its scan engine technology. Unless you clearly understand the impact
of your changes to the KDC settings, please do not change factory default settings. Please
refer to Appendix A for details. Pressing the Default icon will reset all symbology related
options to factory default settings.
Data Editing Option
Prefix
- Enables the user to add a prefix to scanned data that may then be stored in KDC or
wedged to the host. The Prefix format must be defined in the data format menu of KTSync.
The maximum length for a Prefix is 11 characters.
This Prefix option is different from the Prefix option in KTSync that appends the
prefix to data during synchronization.
Suffix
- Enables the user to add a suffix to scanned data, which may then be stored in KDC
or wedged to the host. The Suffix must be defined in the data format menu of KTSync. The
maximum length for a Suffix is 11 characters.
This Suffix option is different from the Suffix option in KTSync that appends the
suffix to data during synchronization.
AIM ID - Enables the user to add AIM ID to scanned data, which may then be stored in KDC
or wedged to the host. AIM ID must be defined in data format menu of KTSync. AIM ID is
either added to the end of Prefix or Suffix.
Partial Data
: Enables the user to display and store partial data. The user defines the start
position and number of characters to be displayed and stored.

Select the
x
characters from
y
position

Set Partial Data Start Position to
y
, Partial Data Length to
x,
Partial Data
Action to Select.

Partial Data Length
0
selects all characters from
y
position.

Erase the
x
characters from
y
position

Set Partial Data Start Position to
y
, Partial Data Length to
x,
Partial Data
Action to Erase.

Partial Data Length
0
erases all characters from
y
position.
Note
Note