3.2.2
Internal temperature sensor
Parameter name
Values
Calibration offset
-50 ...
0
... 50 (x 0.1ºC)
Sending period
0
... 255 (x 10 s, 0 = Disabled)
Send when change is greater than
0
... 255 (x 0.1ºC, 0 = Disabled)
This section allows configuration of the internal temperature probe.
The
Calibration offset
parameter defines the initial value of the calibration offset to be added
to the measured temperature values. This offset can also be adjusted from the user interface
(System settings > Temperature Probe)
The corrected temperature values are made available through the
Internal temperature
com-
munication object (DPT 9.001). The
Sending period
and
Send when change is greater than
parameters can be used to control when this object is updated (and its value sent to the bus)
3.2.3
Timer groups
Parameter name
Values
Timer group 1 lock object
[Checkbox]
Timer group 2 lock object
[Checkbox]
Timer group 3 lock object
[Checkbox]
Timer group 4 lock object
[Checkbox]
As described in
on page 21, timers can optionally be added to one of four
available timer groups. This allows to temporarily lock (disable) groups of timers with a single
operation.
The parameters in this section control whether the corresponding lock objects (
Timer group 1
lock
...
Timer group 4 lock
) are available.
3.2
Main
45
