Motion Detector PIR900 V3.3
©
KNOP
Elektronik A/S
Fabriksvej 20
DK-7600 Struer
knop.dk
+45 97840444
7
ByPass/Delay options
You can set the ByPass and delay time in several ways in PIR900.
In this section, we will try to explain two examples of how they can be set.
In the first example, ByPass is set to on and Delay is set to d1.
When ByPass is on, PIR900 starts counting down from 9 to 1, after which it starts sending an
alarm. If Delay is set to d1, PIR900 cannot send messages again until after one minute of silence
in front of the PIR element.
In the second example, ByPass is set to off and Delay is set to d0.
When ByPass is set to off, PIR900 starts sending an alarm when it is activated. If Delay is set to
d0, PIR900 can send notifications when there is an activity in front of the PIR element.
Battery alarm
Each time an alarm is sent, the battery is checked.
If the battery voltage is low, a beep will be heard every 7-10 seconds. When an alarm is sent, "LO
BA" flashes in the display.
At the same time, low battery status is sent to the receiver in the system.
Replacement of batteries
●
Remove the battery cover at the back of the product.
●
Insert two new LR6 Alkaline batteries.
●
Remember to insert them correctly. See marking in the battery compartment.
●
Check the product is working correctly.
