UIP-HDMI Balun Specifications:
Dimensions
UIP-HDMI (box style version): 4" h x 3-1/4" w x 1”d. (104 x 84 x 26 mm)
Inputs and Outputs
:
Sender Unit: One HDMI input jack, one RJ-45 out-jack, one 2.1 mm DC
power input.
Receive Unit: One HDMI output jack, one RJ-45 in-jacks, one 2.1 mm DC
power input
Power:
Each Sender and Receiver needs one 5VDC 2000 mA power supply.
Center is positive.
Temperature Range:
-5 to +35 C (+20 to +95 F)
Warranty
Knoll Systems warrants its products sold in the USA and Canada by authorized Knoll dealers to be
free of defects in materials and workmanship. This warranty extends for three full years from the
date of purchase by the original consumer. Any products returned to Knoll Systems and found to be
defective by Knoll Systems within the warranty period will be repaired or replaced at Knoll Systems
option, at no charge. Knoll Systems will not be responsible for the actual cost of installation or
removal of the product, nor for any incidental or consequential damages. Some states do not allow
the exclusion or limitation of incidental or consequential damages, so the above limitation may not
apply to you. This warranty gives you specific legal rights. You may have additional legal rights that
vary from state to state.
Knoll HDMI baluns pass HDCP and digital audio signals without manipulating them in
any way.
Knoll Systems
www.knollsystems.com
145 Tyee Drive Point Roberts, WA 98281
12140 Horseshoe Way, Richmond BC V7A 4V5
Tel. (604) 272 4555, fax (604) 272 5595
Made in China Knoll Systems All Rights Reserved
UIP-HDMI
Installation Instructions v1.0
Warning
: To be installed and/or used in accordance with appropriate electrical
codes and regulations.
If you are unsure about any part of these instructions,
consult a qualified electrician.
Introduction:
Thank you for purchasing a Knoll active balun system. This system
is specifically designed to send 1080p HDMI signals safely down one cat 5e or
cat 6 wire up to 330 feet (100 meters) or 660 feet (200 meters) over an Ethernet
system (resolutions lower than 1080p will transmit to further distances).
To install wires inside walls, in most jurisdictions require wires to be minimum
class 2 rated for safety. Almost all conventional HDMI wires are unrated so they
cannot legally be installed inside walls. The most cost effective method to install
a legal HDMI inwall run is to use cat 5e wire and Knoll HDMI baluns.
Features:
Connects up to 330 feet with one cat5e wire.
Will safely send 480i/p, 576i/p, 720p and 1080i/p.
Equalization, level correction as well as clock and data recovery
retiming are fully automatic.
Can be connected through an Ethernet up to 660 feet at 1080p.
When used with Ethernet, as many Receivers as required can be used
with multiple displays receiving HDMI video and sound.
