Knick Unical 9000, Installation Manual

Page: 59 / 80

59
First select “Plug and Play” in the Parameter Setting menu of the Protos:
The Unical 9000(X) probe controller automatically recognizes the hardware
installed and sets the corresponding installation parameters.
13 Commissioning
Start-Up on the Protos: Automatic Hardware Recognition
(Parameter setting/System control/Factory setting/Probe control...
Opening the parameter setting
menu
From the measuring mode:
Press menu key to select menu.
Select parameter setting using arrow
keys, press
enter
to confirm.
Menu Display Plug and Play
Parameter setting:
Select “System control”.
Menu selection
Return to meas
7.05 pH
25.6°C
Select: [enter]
Lingua
Parameter setting (Administrator)
Probe control
Return
25.6°C
Module BASE 3400-021
7.05 pH
System control
Module FRONT 3400-011
OK
Factory setting (Administrator)
The factory setting erases
all your set parame
Return
25.6°C
Measuring system
7.05 pH
Probe control
Block
First select “Probe control”,
then select “Plug & Play”.
The hardware installed is automati-
cally recognized.
Programs only
No
Module PHU 3400-110
Complete
Plug&Play
System control (Administrator)
Return
25.6°C
Logbook
Buffer table
7.05 pH
Factory setting
Software update
Select “Factory setting”.
Passcode entry
Release of options