Knick Stratos Pro A4 MSOXY, Instruction Manual

Page: 22 / 140

22
Measuring Mode
After the operating voltage has been connected, the analyzer
automatically goes to “Measuring“ mode.
To call the measuring mode from another operating mode
(e.g. Diagnostics, Service): Hold meas key depressed (> 2 s).
Sensoface indicator
(sensor status)
Time
Mode indicator
(measuring)
Hold meas key
depressed to call the
measuring mode
(pressing once more
switches the display)
enter key
In measuring mode the display indicates:
• Measured values as selected (OUT 1 / OUT 2) and time (24/12 h
AM/PM) or temperature in °C or °F (formats selected during
configuration)
By pressing the meas key in measuring mode you can view the
following displays (for approx. 60 sec):
• Measured values channel A and measured values channel B
• Measured value and tag (point of measurement designation –
entered during configuration)
• Time and date
• Controller (if configured), upper display: controller output Y,
lower display: setpoint (can be edited)
Pressing the enter key shows the output currents. They are displayed
as long as enter is held depressed, then the measured-value display
will return after 3 sec.
You must configure the device for the respective measurement
task!
Process variable
(pH)
Process variable
(Oxy)