Knick Stratos Evo A402, User Manual

Page: 60 / 196

60 60
Cond Configuration
Device Type: Cond
Connected modules are automatically recognized. When no
module is installed, but a Memosens sensor is connected at
initial start-up, it is recognized and the corresponding process
variable is automatically selected. In the SERVICE menu you
can change the device type. Afterwards, you must select the
corresponding calibration mode in the CONF menu.
1 Press menu.
2 Select CONF using

,
press enter.
3 Select parameter set using

keys,
press enter.
4 Select SENSOR menu using

keys,
press enter.
5 All items of this menu group are indicated by the
“SNS:” code.
Press enter to select menu,
edit using arrow keys (see next page).
Confirm (and proceed) by pressing enter.
6 Exit: Press meas key until the [meas] mode indicator is
displayed.
6
5
Select sensor type
Enter cell constant
Select measuring mode
Select measuring range
Concentration determination
Temperature unit
Temperature detection
Select type of temp probe
Cleaning cycles
Sterilization cycles
CHECK TAG
CHECK GROUP
5