Knick PORTAVO 904X PH, User Manual

Page: 35 / 68

35
Options
Scope:
Cal SOP Calibration Method
The calibration method must be configured using the Paraly SW 112 PC software.
Here, you specify which buffers are to be used in which sequence. You can combine
buffer solutions from different buffer sets. Please note that the minimum distance
allowed between two buffer solutions is Δ 2 pH units.
SOP calibration allows you to:
• select up to three calibration points and three buffer sets.
• add a verification buffer.
• specify a maximum deviation (0 ... 0.5 pH units) for the verification buffer as delta
pH.
Sensor Verification
The Paraly SW 112 PC software allows a sensor to be assigned to the device. See the
Paraly SW 112 PC software user manual.
Setup / Cal / Logger Code
Access codes can be set on the meter or using the Paraly SW 112 PC software;
see page 37.
Configuration: SETUP CODE
Calibration: CAL CODE
Data logger: LOGGER CODE
Without entry of an access code, the data logger will only display logger data (
RCL
).
Temperature Calibration
(also separately available as Option 002 TEMP.CAL)
Option 002 TEMP.CAL (Temperature Calibration)
For Memosens sensors, you can perform a 1-point calibration of the internal
temperature detector. See the Calibration chapter for a description.
Option 001 SOP (Standard Operating Procedure)