14
2. Intended Use
The BasicLine BL 513 standard-signal isolators are used for galvanic isolation
of 0(4) to 20 mA and 0 to 10 V standard signals. DIP switches allow selection of
calibrated input and output signals. Fine-adjusting is not required.
Signal transmission is linear. The universal power supply allows operating the
device with 24 V DC or with 100 ... 230 V AC. Connection is made using screw
clamp terminals.
Caution!
Be sure to take protective measures against electrostatic discharge
(ESD) when handling the devices!
Caution!
Only trained and qualified personnel should install the BasicLine BL 513
standard-signal isolators.
Do not connect the device to power supply before it is professionally installed.
Do not change the measuring range during operation. Observe the national
codes and regulations for installation and selection of cables and lines.
Equipment shall be provided with a means for disconnecting it from each
operating energy supply source. The disconnecting means shall disconnect
all current-carrying conductors.
It must be easily accessible and clearly identifiable by the operator.
Mains supply must be protected by a fuse ≤ 20 A.
The warning symbol on the device (exclamation point in triangle)
means: Observe instructions!
Warning! Protection against electric shock
For applications with high working voltages, take measures to prevent
accidental contact and make sure that there is sufficient distance or
insulation between adjacent devices!
1. Safety Information
