22
Figure 7-4
Securing the circular knife
To do so, hold the knife holding fixture with the
locking pin (7-4/1) and tighten the star handle
(7-4/2) by rotating clockwise.
7.1.2 Positioning circular knives on the grinding wheel
The cutting edge of the circular knife (7-5/1) must
be approx. 15 mm in front of the center of the
grinding wheel.
To do this, loosen the lower clamping lever (7-6/1)
by rotating counterclockwise and move the entire
grinding attachment (7-6/2) until the cutting edge
of the circular knife is approx. 15 mm in front of
the center of the grinding wheel (see figure 7-5).
Retighten the lower clamping lever (7-6/1).
7. Operation
Figure 7-5
Positioning the circular knife on the
grinding wheel
Figure 7-6
Adjusting the circular knife grinding
attachment
1
2
1
1
2
