AZURA® Valve Unifier VU 4.1 Instructions V6855
Unpacking and setup 13
To set up a LAN, we recommend to use a router. That means the following
steps are required:
1.
On the computer, go to the control panel and check the LAN
properties.
2.
Hook up the router to the devices and the computer.
3.
On the computer, configure the router to set up the network.
4.
Install the chromatography software from the data storage device.
5.
Switch on the device and run the chromatography software.
6.5.1
Configuring the LAN settings
The LAN uses only one server (which is normally the router) from that the
devices automatically receive their IP address.
In Windows, power saving, hibernation, standby, and screen saver
must be deactived.
In case you use an USB-to-COM box, the option “Allow the computer
to turn off ths device to save power” in the devicemanager must be
deacti vated for all USB hosts.
For all LAN devices: For the network adapter, the following option in
the Device Manager must be deactivated: “Allow the computer to turn
off this device to save power”.
1.
In Windows open the
Network and Sharing Center
.
2.
Double-click on
LAN Connection
.
3.
Click on the button
Properties
.
4.
Select
Internet Protocol version 4 (TCP/IPv4)
.
5.
Click on the button
Properties
.
6.
Check the settings in the tab
General
. The correct settings for the
DHCP client are:
a)
Obtain IP address automatically
b)
Obtain DNS server address automatically
7. Click on the button OK
.
Process
Prerequisites
Process
