Unpacking and Setup
17
P 2.1S/P 4.1S user manual V6870, version 3.1
Next steps:
Finish the installation and perform the initial startup.
Computer Control
This section describes how to set up an HPLC system in a local area network
(LAN) and how a network administrator can integrate this LAN into your com-
pany network. The description applies to the operating system Windows® and
all conventional routers.
Note:
To set up a LAN, we recommend to use a router. That means the follow-
ing steps are required:
Process:
1. On the computer, go to the control panel and check the LAN properties.
2. Hook up the router to the devices and the computer.
3. On the computer, configure the router to set up the network.
4. Install the chromatography software from the data storage device.
5. Switch on the device and run the chromatography software.
Configuring the LAN Settings
The LAN uses only one server (which is normally the router) from that the
devices automatically receive their IP address.
Prerequisite:
In Windows
®
, power saving, hibernation, standby, and screen saver must be
deactived.
Process
Figure
1. Place the terminal strip
3
on a
suitable surface.
2. Push the depressor tool
1
into
the opening on the upper side.
3. Continue pushing the depressor
tool down and lead the cable
2
into the front end of the termi-
nal strip.
4. Remove the depressor tool.
5. Check whether the cables are
tightly attached.
6. Plug the terminal strip onto the
multi-pin connector.
Fig. 7
terminal strip
1
2
3
