WIRE HALF MOON PIVOT-OUT
LAZY SUSAN
Installation Instructions
KNAPE & VOGT MANUFACTURING COMPANY
P.O. Box 191, Muncie, IN 47308
0.899.6535 • 765.288.8730 • Fax 765.288.0851 • www.kv.com
RN-248EFS 04/03
Inspect all parts and read all instructions prior to beginning assembly and installation.
Parts Included
A. Half-moon shelf assembly
B. Side C-Hinge
C. Pin and plastic washers
D. Door follower and screws
E. Mounting screws
Tools Required
• Phillips Screwdriver
• Drill with 1/16” bit for pilot holes
Product Assemblies
HM25
HM28
HM30
HM34
Step 1
Locate cabinet side for attaching half moon susan
shelf. Wrap the C-hinge around the cabinet frame so
the tabs hold the pin inside the cabinet. Screw C-
hinge into place using two long screws in the side
of the cabinet face frame, and 4 short screws into
the back of the cabinet face frame.
Step 2
Position plastic washers over holes in the C-hinge.
These will ensure smooth operation during shelf
pivot movement. Align the holes on the bracket of
the half moon shelf assembly with the holes in the
C-hinge. Slide pin through all four holes from the top
downward.
Step 3
Hook the door follower up and around the top wire
surround of the half moon shelf, and screw to back
side of cabinet door. Caution: Make sure the
mounting screws are shorter than the thickness of
the door to prevent the screws from going through
the door front.
A
step 3
step 2
step 1
D
B
E
Pin
Washer
Basket
hinge
bracket
Tab
Short
screws
Long
screws
C