10
Risk of health consequences
If the freshness cooler is handled impro-
perly or if there is a lack of control, there
is a risk that the food stored in the fresh-
ness cooler will be damaged and possi-
bly spoil.
If the freshness cooler is disconnected
from the power supply unexpectedly,
e.g. in the event of a power failure, the
person responsible on site must ensure
that the stored food is checked. Compli-
ance with the prescribed storage tem-
perature must be ensured.
Clean up spilled liquids in the goods area
immediately.
Risk of injury
There is a risk of injury if used improperly.
Check at regular intervals whether there
are foreign objects in the goods area
and remove them.
If defrost water leaks out of the freshness
cooler, wipe it up immediately; otherwise
there is a significant risk of people slip
-
ping and injuring themselves.
When cleaning the freshness cooler,
always use suitable protective gloves to
protect against injuries from sharp de-
vice edges.
The market operator himself commit to
repair minor damage to the freshness
ooler that does not impair any technical
functions (e.g. dents in the housing cau-
sed by shopping trolleys).
If there is damage to the refrigeration
system or the electrics, the KMW custo
-
mer service must be informed immedia-
tely. Otherwise there is a considerable
risk of injury.
In case of improper handling or use, the
-
re is a risk of damaging the cooler and
causing property damage.
Always make sure that the freshness
cooler is level on all sides and stands on
all four feet securely when you put it into
operation.
Observe the installation instructions in
these operating instructions.
Never expose the freshness cooler to
direct sunlight and keep the freshness
cooler away from heat sources.
Always note that the freshness cooler
must not heat up above the following
temperatures: +50°C (during operation)
and +70°C (during transport and sto-
rage).
Malfunctions caused by electromagne-
tic interference
Improper installation of the temperature
controller or improper connection to the
Wurm system can result in malfunctions.
Only use shielded data lines for installa
-
tion and connection.
When installing the data lines, keep a
large distance to load lines.
