KMC Controls, 19476 Industrial Drive, New Paris, IN 46553
/
877.444.5622
/
Fax: 574.831.5252
/
STE-9000 Series NetSensors
Installation Guide
REMOVE BACKPLATE
1. Turn the
hex screw
1
clockwise into the
sensor until the screw clears the cover.
1
NOTE:
The hex screw
2
should remain in the
backplate.
2
2. Pull the cover off the backplate.
CONNECT ETHERNET CABLE
3. Feed the
Ethernet patch cable
3
from the
Conquest controller through the center of the
backplate
4
.
NOTE:
The Ethernet patch cable should be a
maximum of 150 feet (45 meters).
3
4
INTRODUCTION
Complete the following steps to mount a KMC
Conquest STE-9000 Series Digital NetSensor
and connect it to a Conquest BAC-59xx/9xxx
Controller.
STE-90xx/93xx
STE-9xxxW-NDL
(no display)
KMC
Conquest
TM
Automation Hardware
NOTE:
See the
9000 Series Digital Room Sensors
data sheet and the
specifications and other information.
NOTICE
OBSERVE PRECAUTIONS
FOR HANDLING
ELECTROSTATIC
SENSITIVE DEVICES
SELECT MOUNTING LOCATION
See the
Room Sensor and Thermostat Mounting
Location and Maintenance Application Guide
for
cautions, troubleshooting, and best practices.
NOTE:
Complete rough-in-wiring at each
location before installing a sensor.
STE-92xx/95xx
with Motion Sensor
