Complete the following steps to install a
Conquest™ BAC-5051 BACnet Router.
Refer to the
Conquest BAC-5051E BACnet Router
data sheet for router specific information on the
web at
kmccontrols.com
.
INSTALL CONTROLLER
NOTE:
Complete steps 1–2 to install the
router with screws.
Complete steps 3–7 to install the
router on a 35 mm DIN rail.
NOTE:
Install the router in a metal UL
approved energy management
equipment panel.
1. Position the router so the removable color
coded
terminal blocks
1
are easy to access
for wiring.
NOTE:
The black terminals are for power. The
gray terminals are for communication.
2. Screw a #6 sheet metal screw through the
mounting tab of the DIN Latch on each end of
the
router
2
.
1
2
NOTE:
Pull out each DIN Latch mounting tab
one click to be 6 inches on center for
mounting.
BAC-5051 BACnet Router
Installation Guide
NOTE:
Complete steps 3–7 to install the
router on a 35 mm DIN rail.
3. Position the
DIN rail
3
so that when the
router is installed the color coded terminal
blocks are easy to access for wiring.
4. Pull out one of the
DIN Latch
4
until it clicks
once.
5. Position the router so the top
tab
5
of the
DIN release rests on the DIN rail.
6. Lower the router against the DIN rail.
7. Push in both
DIN Latch
4
to engage the DIN
rail.
NOTE:
To remove the router, pull the DIN
Latch until it clicks once and lift the
router off the DIN rail.
3
5
4
KMC Controls, 19476 Industrial Drive, New Paris, IN 46553
/
877-444-5622
/
Fax: 574-831-5252
/
www.kmccontrols.com
