BAC-19xxxx FlexStat Installation Guide
7 926-019-02C
MS/TP NETWORK ACCESS PORT
The MS/TP EIA-485 data port on the bottom of
the cover provides technicians temporary access
to an
MS/TP
network (not Ethernet) using an
,
, and
. See
the documentation for those products for details.
Illustration 14—MS/TP (EIA-485) Data Port
CONFIGURATION AND PROGRAMMING
To set up the FlexStat from the touchscreen:
1. Push and hold the upper left corner of the
screen (space temperature reading) to start.
2. Select the desired options and values. See the
BAC-19xxxx FlexStat Application Guide
details.
Settings (Press Space Temp)
Occupancy Override
Fan Auto or (Constant) On
Active Cooling Setpoint
Heat/Cool/Auto/Off Mode
Active Heating Setpoint
Units (°F or C)
Illustration 13—Screen Menus Access (Default)
NOTE:
Options in menus are dependent
on the FlexStat model and selected
application.
Advanced configuration of a FlexStat can be done
through software. See the
for the most relevant KMC
Controls tool for additional configuring, program
-
ming (with Control Basic), and/or creating graph-
ics for the controller. See the documents or Help
systems for the respective KMC tool for more
information.
MAINTENANCE
To maintain accurate
temperature and humidity
sensing, remove dust as necessary from the venti-
lation holes in the top and bottom of the case.
To maintain maximum sensitivity of the built-in
motion
sensor, occasionally wipe dust or dirt off
the lens—but do not use any fluid on the sensor.
To clean the case or display, use a soft, damp
cloth (and mild soap if necessary).