Laser Surgical Unit diomax
®
Revision 6
47
5.12.3
Program change
The active program can be changed and saved.
The rotary knob is used to select the parameter to be changed. Pressing the rotary knob
activates the selected parameter. Its type or value can then be changed by turning the rotary
knob. Pressing the knob again confirms and applies the parameter change. The marking
modified
is shown next to the program name on the right side of the display when a laser
parameter of the current program is changed.
Modified
disappears when the program is
saved under the same or a new name, see section 5.12.7 “Saving the Modified Program”,
page 51.
The adjustable parameters are described in the following sections.
5.12.4
Laser output
•
Laser power (Laser output)
Use the rotary knob to select and adjust
(0.1 - 20 W)
•
Output from 0.1 to 20 W can be selected in
continuous mode, pulsed mode, cycle mode
and single mode
•
Output from 1 to 20 W can be selected in
the continuous rate and pulse rate operating
modes.
5.12.5
Operating modes
•
Operating mode
Use the rotary knob to select the mode and
activate it by pressing the knob. Select the
desired operating mode from the list.
