background image

KICKER AMP 

&

 SPEAKER

INSTALLATION GUIDE

FOR USE WITH VICTORY CROSS COUNTRY TRUNK

> Step-by-step Installation Guide
> 5 1/4” Kicker Speakers Pair
> Kicker Amp 100W/50W
> Stainless Steel Mounting Bracket
> Custom Wiring Harness 
> Black Heat Shrink

>  Black Cable Tie
>  All Necessary Hardware

 

- 8 - 32 x 1/2” Button Head Bolts

 

- 8 - 32 Nylock Nuts

INCLUDED IN THIS FIT KIT:

Summary of Contents for VICTORY CROSS COUNTRY KICKER

Page 1: ...TRY TRUNK Step by step Installation Guide 5 1 4 Kicker Speakers Pair Kicker Amp 100W 50W Stainless Steel Mounting Bracket Custom Wiring Harness Black Heat Shrink Black Cable Tie All Necessary Hardware 8 32 x 1 2 Button Head Bolts 8 32 Nylock Nuts INCLUDED IN THIS FIT KIT ...

Page 2: ...nplug the 2 pin power connector on the new harness and set the piece with the fuse aside at this time 9 From the inside left of the trunk thread the left side speaker wires blue trigger wire and power leads through the existing holes behind the left side speaker Pic 8 10 Route the power leads along the existing trunk harness and under the left side cover Pic 9 11 Route the blue trigger wire under ...

Page 3: ... Reinstall speaker grilles AMP INSTALLATION 17 Remove the black 8mm fastener in the front left of the trunk floor place the amp bracket over that hole and loosely reinstall the black 8mm fastener Pic 13 18 Positioning the amp bracket over the holes for the lower backrest reinstall the backrest using the original hardware and torque fasteners Pic 14 19 Install amp onto amp bracket with supplied har...

Page 4: ...e harness down the left frame tube and route the fuse and leads into the battery box area Pic 17 24 Attach the leads to their respective battery terminals Note At this time it is highly recommended to follow the guidelines in your Kicker PX 100 2 owner s manual to set up the amplifier Klock Werks recommends that the dip switches be set up as follows AUTO TURN ON 12V INPUT LEVEL HI HI PASS OFF INPU...

Reviews: