26
KCS Monitor Reference
Klippel R&D System
2.4.2
Nuvoton Audio Development Platform
Perform the following steps and connect the hardware according to the following pictures.
1.
Make sure the
D11 jumper
removed if using NAU83G10 and connected if using NAU83G20
2.
Connect the speaker
. Make sure the polarity is correct.
3.
Connect the power supply
. If you change or reconnect the speaker later, unplug the power
supply before to avoid hardware failure due to accidental shorting of pins.
4.
Connect USB
to the PC
See Nuvoton’s
NAD Quick Start Guide
for more information.
NAU83G10
NAU83G10
: Do not use a power supply with a voltage higher than 5.5V. This would damage the chip.
NAU83G20
