Page 26 of 30
Version 1.3
© KLING & FREITAG GMBH
User's Manual
K&F
VIDA M Accessories for Mobile Use
7
Care and Maintenance
8
Transportation and Storage
Store the product in a dry place. Also, transport under dry conditions only.
During prolonged storage, ensure sufficient ventilation.
Avoid vibrations during transport.
Avoid mechanical stress during transport and storage, so the product is not damaged.
9
Disposal
Dispose of this product according to local ordinance regulations.
Ensure that the product cannot be re-used or used otherwise after disposal.
WARNING
Risks imposed by falling or overturning parts
1. Over time, the accessories may exhibit signs of wear, for example, from mechanical strain,
transport damage, corrosion, or improper handling.
As a basic principle, you must visually inspect the speaker accessory before and after you
use it. For fixed installations, you must inspect it for signs of wear at regular intervals.
When performing those checks, particularly look for deformations, cracks, dents, damage
to threads, and corrosion. Also check slings and lifts (e.g. shackles, chains, and steel ropes)
carefully for wear and deformation.
If as a result of these checks any uncertainty should arise with regard to safety or if specific
faults are found, stop using the accessories and send in the product to KLING & FREITAG
for inspection and repairs, if necessary.
Inspection regulations may vary depending on application and country of use. Observe all
applicable regulations; If in doubt, contact local authorities.
Many countries require regular inspection of mounting components and accessories. An
additional annual inspection is typically required to be performed by a technical expert as
per applicable regulations. Moreover, a legally certified or official authority must perform
a detailed inspection every four years.
Therefore, be sure to maintain an inspection log. Enter the values determined for each
speaker and accessory during the periodic checks into this log. This way, relevant data are
always at hand in case of inspection. This inspection log book shall be updated with the
inspection steps, test intervals and parts lists.
2. Clean this speaker accessory regularly using a corrosion-prevention penetrating oil (for ex-
ample, WD-40).
