22
filtering unit
STRONG
-
5000
-
S
15.10.2019
Periodically remove
the condensate water drippings and the
impurities
from
the dewatering filter
of
the compression
air
system
and the compression air tank
– the valve is placed on the device
housing.
In case of
non-
typical disturbances
follow the
instructions
as in Section 8 of the present Use and
Maintenance Manual. Every 12 months of operational use
– clean and examine the fan and
the motor according to the requirements of the motor manufacturer.
Every three months, check the pollution state
of the extraction ductings,
clean them when necessary.
10. Occupational Health and Safety
Prior to start and use,
it is important to get acquainted with the present Manual. For the sake of
safety,
connect the device to the power supply system
strictly according to the enclosed
electrical diagram
and in compliance with the being in force regulations within the range of per-
sonal protection from electrical shock.
Any work related
to connection to the
electrical power system ought to be
performed exclusively by an authorized person with testified qualifications.
For safety reasons, the pressure of the supplied compressed
air, should not exceed 0,8 MPa
– the
recommended value is 0,6 MPa.
Repair should be carried out after the fan is switched off and the device is
disconnected from the power supply mains.
11. Transport and Storage
STRONG-5000-S filtering unit has to
be transported in two assemblies protected in foil
, placed on
on transport pallets. For the transport time the device should be placed
in vertical position and
protected from an uncontrolled overturn and displacement.
While assembling the device
at the User’s location, follow the guidelines included in Section 6
“Assembly and Start-up”. As the device is a thin-wall
construction handle with care
while lifting the
subsequent assemblies during the transport, reloading and installing. The unit has to be stored
in dry rooms and areas of efficient ventilation.
12. Terms of warranty
The period of warranty for the purchased device
is
indicated in the
“
Card
of
Warranty”. The
warranty does not comprise:
● mechanical damage and malfunctions caused by User,
● device failures caused during the use which is in contradiction with the purpose
of appli-
cation
and with the present Use and Maintenance Manual,
● malfunctions resulting from the improper transport, storage or incorrect maintenance.
Infringement of the
Section 3 “Reservations of Producer” of the present Use and
Maintenance
Manual
and,
especially modifications
undertaken by User on one’s own or use in contradiction
with the
purpose
of
application
–
shall result in the loss of warranty validity.