90°
www.klik
usa
.com -
sales
@klik
usa.com
Push LEDPOD in until it snaps into place
and the outer surface is flush with the
outer surface of the tube.
Prod the rim of the clear silicone
IP Seal
to
provide a tighter fit.
The notch indicates
the direction of the light,
Asymmetrical LEDPods
Light
direction
LEDPOD Removal Steps
Insert removal tool into the
2mm holes in the LEDPOD
.
With firm pressure, rotate
the LEDPod 90°
.
Carefully peel back
the IP silicone seal
one side at a time.
Carefully remove the LEDPOD
from the cl
i
p, ensuring not to
damage or disconnect wires in
the process.
Be sure to re-attach
the silicone seal ready
for reinsertion.
NEGATIVE [ - ]: Black
POSITIVE [ + ]: Red
9
1
2
3
Thru.
wire
Pull a loop of wire through hole.
Rotate retaining cl
i
ps in as shown. Avoid
tangling or severing through wire.
3
4
5
Apply pressure as shown to deform cl
i
p into place in
a
circular motion. Avoid damaging the surface of tube
and tangling or severing through wire.
PAGE 1 OF 2
Install Scotchlok connectors to the (0.75-1.5sq)
red
and black wires. Connect the corresponding
color
wires of the
d
river to the Scotchloks and
assure the
cl
i
p is secured.
CAREFULLY feed the Scotchloks to the left
of the cl
i
p and the driver to the right with the
driver connector hanging out. Ensure wires
are clear from where the LEDPOD is to fit.
Proceed to connect the LEDPOD
.
6
7
8
Fit cl
i
p into place until the clamping
ends are equally cent
ered
over the
hole.
Use the tool to cent
er
the cl
i
p until
equal pressure can be felt and inspect
by eye.
Feed through appropriate
wires
(0.75-1.5mm²).
2
Make sure drilled holes are
deburred and excess swarf
is removed from railing.
1
32863-C
.1
Ø 0.98”
Ø 1.02”
1.18”
OD
1.50”
1.66”
Use a 25mm annular
cutter to bore hole.
(Use 1” in aluminum.)
Aprx 2”
KLIK LEDpod™ 40 Installation Instructions
Ø 25 ± 0.2mm
