CANX3-KIT
Installation and Operation Manual
PG 41/44
REV: A (9/4/2020)
9.4.2.
Insert all wiring into included wire loom and ensure loom is away from all sharp edges, hot vehicle parts
(i.e., exhaust, engine, radiator), and fasten securely to vehicle using zip ties, or equivalent.
NOTE:
Do not cut wires to length until 100% sure of length required for final connections.
9.4.3.
Install supplied fuse holder on end of power wire by cutting the loop in fuse holder and connecting
supplied Ring terminal to one end and Butt connector on other end.
CAUTION:
Do not install 30-amp fuse until all electrical connections are final.
9.5.
Install Horn Button
9.5.1.
It
’s recommended to install Horn Push Button (
) in OE location designed for aftermarket switches and
accessories, found at center console, as shown below.
Figure 40
–
Recommended install location for Air Horn Button
9.5.2.
If desired otherwise, find another suitable location that
has 1”+ of clearance behind for terminals
, then
mark location for drilling. D
rill a 3/4” hole
at location. Route horn button wires to hole then slide push-
button retaining nut over wires and connect per wiring diagram. Install push-button into hole and tighten
retaining nut securely on backside.
9.6.
Connect Air Horn Solenoid(s)
Route wiring, as desired up to Air Horn and connect to Solenoid.
9.7.
Pressure Switch
9.7.1.
Route wiring, as desired back to Air Tank and connect to Pressure Switch.
End of Section
Horn
Button
