CANX3-KIT
Installation and Operation Manual
PG 23/44
REV: A (9/4/2020)
8.4.4.
Install Air Tank Bracket X3-201 onto Rack support tubes, using
shown below. Hand-tighten hardware only, so Bracket can still be adjusted for Air Tank, as needed.
NOTE: first re-install large rear OE bolt to hold Bracket in place, then use a magnetic tool to hold
Coupling Nut and Washer together and insert them into Support Tube.
Figure 10
–
Installing Rear Air Tank Bracket, Exploded View
8.4.5.
Ensure Coupling Nut and Washer are correctly installed inside Tube, as shown below.
NOTE: To hold Coupling Nut while tightening screw, use an SAE standard 10mm open end wrench
Figure 11
–
Installing Rear Air Tank Bracket, Proper Bolt Orientation (partial bracket shown)
FRONT
FRONT
Gap exists above
Coupling Nut
inside of Tube
Re-Use
H13
X3-201
H11 (3)
H15 (4)
H16
H12
Use Later
Use Later
