CANX3-KIT
Installation and Operation Manual
PG 19/44
REV: A (9/4/2020)
8.
On-Vehicle Mechanical Assembly Steps
8.1.
Plan Location of Quick Connect Air Coupler
8.1.1.
Before installing Brackets, review how kit installs and decide whether to install coupler to vehicle body,
frame, or onto supplied brackets; this facilitates later routing Air Tubing and attaching Coupler.
NOTE: Some installers may choose to directly fasten Quick Connect Coupler to Air Compressor, Air Tank,
or Air Horn Brackets by using self-tapping screws or drilling a hole for Coupler itself. Although this is
common practice, modification of Brackets in any way voids their warranty.
8.2.
Remove Passenger side Rear Fender
8.2.1.
Remove seven (7) T30 screws from top of fender and corner trim, as shown circled in below figure.
8.2.2.
After removing screws, remove five (5) accompanying body clips on top of rear fender and two (2) on
corner trim.
CAUTION: Use care removing body clips and corner trim; corner trim has a hidden clip on backside. All
items removed will be re-used later.
Figure 2
–
Passenger Rear Fender Removal (fasteners on top of fender)
8.2.3.
Remove three (3) additional T30 screws; two (2) located behind passenger door and one behind panel in
wheel-well area as shown below. Un-clip wire loom from body panel for ease of moving fender.
Figure 3
–
Passenger Rear Fender Removal (fasteners behind door and fender)
2X Trim Screws
5X Fender Screws
Behind Door
Behind Fender
