4-4
CHAPTER 4 Equipment Maintenance
HydroChart 5000 Sonar Operations and Maintenance Manual
P/N 11210080, Rev. 02
4.
Turn the Sonar Head Unit on
its side.
5.
Using the 5-mm hex key,
remove the six M6 x 18 mm
socket head cap screws that
secure each of the two skid
plates to the frame, and then
remove the plates and set
them aside.
6.
Remove the six M6 x 12 mm
Phillips head screws that
secure the bottom of the
fairing to the frame.
Figure 4-2:
Removing the Skid Plates from the
Frame
Skid plates
Figure 4-3:
Removing the Phillips Head Screws
from the Bottom of the Fairing
Summary of Contents for HydroChart 5000
