Kleenmaid LEK37A, Installation Manual

Page: 10 / 32

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
506066 8
Before You Start
Tools
For most installations, the basic tools you will need are:
Figure 1
Gas
Dryer is equipped for Natural Gas with a 3/8 inch NPT
gas supply connection. For more detailed information,
refer to section on
Gas Requirements .
Location
Place the dryer on a solid floor with an adequate air
supply. For more detailed information, refer to section
on
Location Requirements .
Exhaust
Use rigid metal duct and exhaust the dryer to the
outside by the shortest route possible.
Figure 2
NOTE: For more detailed information, refer to
section on
Dryer Exhaust Requirements .
Electrical
• ELECTRIC DRYER
Dryer needs a 2 wire plus earth, 250 Volt,
50 Hertz, 20 Amp, single-phase electrical supply.
• GAS DRYER
Dryer needs a 2 wire plus earth, 250 Volt,
50 Hertz, 10 Amp, single-phase electrical supply.
NOTE: For more detailed information, refer to
section on
Electrical Requirements .
If the supply cord is damaged, it must be replaced by a
special cord or assembly available from the
manufacturer or its service agent and is to be replaced
by a qualified service person.
D818I
1 Wrench
2 Screwdrivers
3 Level
4 Teflon Tape
5 Duct Tape
1
2
3
4
5
D314I30A
D314IE0A
Any disassembly requiring the use of tools
must be performed by a suitably qualified
service person.
W299
WARNING