General Operation
•
Run a base station on a known control point, logging GNSS data at 1 second
intervals. Measure height of antenna.
- Alternatively, you can use CORS data within 20km.
•
Turn on your system by connecting one of the USB cables to the power.
•
You should expect to see the Red “Power” LED illuminate. Once the
initialisation process has completed, the Blue “Data” LED will begin to flicker
indicating data is now being written to the micro SD card. If the LED flashes 3
times at 5 second intervals the card has failed and should be reformatted.
•
The Green “GNSS” LED will illuminate when signals are being received from
5 or more satellites.
•
Leave the system running continuously and stationary for at least 5 minutes.
•
Fly the mission with your usual mission planner and flight control.
•
After landing, allow the system to run for a few minutes undisturbed.
•
The system can now be powered down and your data is ready to process with
the KlauPPK software.
To capture checkpoints coordinates:
Centre the camera over your ground mark,
wait at least 2 minutes then take a photo.
Note:
When performing a battery hot-swap ensure the fully charged battery is
connected before disconnecting the flat battery.
Rev- 1.00
9
