Klarstein Tomahawk 3.OT, Manual

Page: 34 / 40

34
EN
OPERATION
Energy saving tips
• Reduce the opening time of the lid.
• Turn the grill off as soon as cooking is completed.
•
Preheat the gas grill for 10 to 15 minutes only. (Except for the first use)
• Do not preheat longer then recommended.
• Do not use a higher setting than required.
• Connect the hose and regulator to the gas cylinder at the left side of the gas
grill keeping in mind that the gas cylinder must be kept away from heat and in
a safe position .The hose dimension is 8-10 mm diameter. The length of hose
recommended which shall not exceed 1.5 m.
CAUTION: The lid must be open when lighting the burner! Do not stand with your face
directly over the gas grill when lighting it.
Lighting instructions
Pilot Gas Control Ignition (Main burner and side burner):
With all gas controls on the gas grill in the "OFF" position, turn on the gas cylinder valve.
To create a spark you must press the control knob A and hold inrthjs position for 3-5
seconds to allow gas flow and then turn anticlockwise to "HIGH" B . It can spark to the
burner lighting tube C . You will hear a snap from the igniter and you will also see an
orange flame coming from the burner lighting tube at the left side offhe burner D.
Continue to hold the burner control knob in for two seconds after the snap, this will
allow gas to flow completely down the burne'riube E and insure ignition.
When the burner is alight, adjacent burers will cross light when their controls are turned
to "HIGH".
At "HIGH" setting the burner flame should be approximately 12-20 mm long with a
minimum of orange flame. Turn the gas control fully anticlockwise for minimum setting.
Should you have any difficulty lighting your gas grill following the above steps, contact
your dealer for advice.
If the automatic ignition can't be used, please remove the cooking grill and heat
diffuser hotplate), and turn the valve anticlockwise to 90° , to light with BBQ lighter in
the istance of 5mm to the burner fire hole. Replace the cooking grill and heat diffuser
(hotplate), please wear the fireproof and heat resisting gloves.
WARNING: If the burner still does not light, turn the burner control knob to "OFF" and
wait 5 minutes to let the gas clear before lighting again.