24
EN
TROUBLESHOOTING
Safety Cut-Out device
To ensure against the potential hazard caused by blockage of the air outlet, this
unit is equipped with an automatic overtemperature safety cut-out device. When the
device is activated the heater will not operate. If this occurs, the unit can be reset using
the following procedure:
1.
Turn the fire off by depressing the on/off switch on the unit.
2. Unplug the power cord form the electrical mains supply socket and leave it
disconnected for at least 15 minutes.
3. Ensure that the air vents are free from obstruction.
4. Plug the power cord back in to the mains socket.
5.
Turn the fire back on.
6.
If the fire fails to operate, check the fuse in the plug.
7.
If the fuse in the plug is OK and the fire is still not functioning, contact a qualified
service person.
Problem
Cause
Check
Stove turns off and-
will not turn on.
.
Stove has overheated
and safety device has
caused thermal switch
to disconnect or home
circuit breaker has
opened.
Reset switch by
turning main power
switch off and wait-
ing 5 minutes then
turning it back on.
Flame is not moving.
Flame motor
defective.
Call a qualified
service technician to
replace flame motor.
