Kiwi Technics Kiwi-30, User Manual

Page: 28 / 66

28
Parameter Editing
Voice Mode Staccato 244 Voice Mode Staccato Options are Staccato/Legato
When staccato is selected every new
note will trigger a new envelope attack
stage. When legato is selected a new
envelope attack stage will only be
triggered after all notes are lifted.
Note - in the initial release Dual & Triple
Legato is disabled.
Detune 144 DCO Detune Range 0-127. DCO Detune will have no
effect on Solo keying
Analogue Feel 145 Analogue Feel This parameter injects a very subtle
random tune adjusts to each note. This
is changed each time a note is played.
Seq One Shot 432 Sequence One Shot Options are Off or On.
This parameter controls whether a seq
will play once and stop (On) or
continuously loop (Off)
Seq Key Down Play 433 Sequence Key Down Play Options are Off or On.
Off = The Sequence will always play
when the Sequence button is on
On = The Sequence will only play when
the Sequence Play button is enabled
and a key is being played.
Use this option with parameter 435 to
control how a sequence finishes.
Seq Auto Transpose 434 Sequence Auto Transpose Options are Off or On.
When on this parameter will transpose
the sequence tune to a key being
played.
Seq Auto Trans Reset 435 Sequence Auto Trans Reset Options are Off or On.
This parameter is used with Parameter
433 and will make Sequence Transpose
temporary (off) or latched (on). When
the transpose is temporary the
sequence will revert back to the
programmed tune as soon as the
transpose key is lifted.
Sequence Complete 436 Sequence Complete Options are Off or On.
This is used in conjunction with the Key
Down play option. When Sequence
Complete is Off the sequence will stop
immediately when the key is lifted.
When SC is set on the Sequence will
run to the point where it loops back to
the start and then finish.
www.kiwitechnics.com Kiwi-30 Upgrade User Manual v121