Installation Guide
Outdoor unit shall be installed at 1.4~1.7 meter above the floor, and the camera shall avoid facing the sunlight directly.
Installation Steps
Connection Diagram for Outdoor Unit
Wire connector of outdoor unit
Manual unlocking switch
Charger 5VDC
outdoor unit
Remark: Provided by users.
Electrolock
Electrolock maintain open if connect
“4”
Electrolock maintain close if connect
“5”
Unlocking power
12VDC
（
-
）
black
（
+
）
red
1.
Drill a hole refer to the dimension, put the screw rubber plug in, then fix the
rainproof cover on the wall by screws.
2.
Connect the charging line according to the wiring diagram(the hole for wire
getting through suggested 16~30mm), if charging line comes from indoor,
lead the charging line pass through the hole, if charging line comes from
outdoor
，
lead the charging line pass through the bottom of rainproof cover
and connect the line .
3.
Install rechargeable lithium battery
（
BP-6M
）
to outdoor unit, the unit
starts up automatically.
4.
Put the top part of outdoor unit into the rainproof cover like the picture,
push the bottom part, make sure its steady and fix it from the bottom by
screw, then fit on the screw cover.
Attentions during Installation:
1. The outdoor photosensitive sensor should
not be hidden or blocked by other objects.
2. Do not face outdoor unit to sunlight
directly.
3. Install the connection line correctly,
otherwise, normal use shall be failure .
