10
NOTE:
Settings are marked on the control knob.
The control knobs can be set to anywhere between H (High) and
L (Low). Push in and turn to setting.
Ceramic Glass
The surface cooking area may glow red when an element is ON.
Some parts of the surface cooking area may not glow red when
an element is ON. The glow will also randomly cycle off and back
on again, even while on High, to keep the cooktop from extreme
temperatures. This is normal operation.
It is normal for the surface of light colored ceramic glass to appear
to change color when surface cooking areas are hot. As the glass
cools, it will return to its original color.
Clean the cooktop after each use to help avoid scratches, pitting,
abrasions and to condition the glass surface. Ceramic glass
cooktop cleaner and a cooktop scraper are also recommended
for stubborn soils. Do not use abrasive cleaners, cleaning pads,
or harsh chemicals for cleaning. The Cooktop Care Kit contains
all of the items needed to clean and condition your ceramic
glass cooktop. Refer to the “Range Care” section for additional
information.
IMPORTANT:
To avoid permanent damage to the cooktop surface
and to make soils easier to remove, clean the cooktop after each
use to remove all soils.
■
Avoid storing jars or cans above the cooktop. Dropping
a heavy or hard object onto the cooktop could crack the
cooktop.
■
To avoid damage to the cooktop, do not leave a hot lid on
the cooktop. As the cooktop cools, air can become trapped
between the lid and the cooktop, and the ceramic glass could
break when the lid is removed.
■
For foods containing sugar in any form, clean up all spills and
soils as soon as possible. Allow the cooktop to cool down
slightly. Then, while wearing oven mitts, remove the spills
using a scraper while the surface is still warm. If sugary spills
are allowed to cool down, they can adhere to the cooktop and
can cause pitting and permanent marks.
■
To avoid scratches, do not slide cookware or bakeware across
the cooktop. Aluminum or copper bottoms and rough finishes
on cookware or bakeware could leave scratches or marks on
the cooktop.
■
Do not cook popcorn in prepackaged aluminum containers on
the cooktop. They could leave aluminum marks that cannot be
removed completely.
■
To avoid damage to the cooktop, do not allow objects that
could melt, such as plastic or aluminum foil, to touch any part
of the entire cooktop.
■
To avoid damage to the cooktop, do not use the cooktop as a
cutting board.
■
Use cookware about the same size as the surface cooking
area. Cookware should not extend more than
1
/
2
" (1.3 cm)
outside the area.
■
Use flat-bottomed cookware for best heat conduction and
energy efficiency. Cookware with rounded, warped, ribbed, or
dented bottoms could cause uneven heating and poor cooking
results.
■
Determine flatness by placing the straight edge of a ruler
across the bottom of the cookware. While you rotate the
ruler, no space or light should be visible between it and the
cookware.
■
Cookware designed with slightly indented bottoms or small
expansion channels can be used.
■
Make sure the bottoms of pots and pans are clean and dry
before using them. Residue and water can leave deposits
when heated.
■
To avoid damage to the cooktop, do not cook foods directly
on the cooktop.
Cooktop On Indicator Light
The Cooktop On indicator light is located on the console panel.
When any control knob on the console panel is turned on, the
Cooktop On indicator light will glow.
Hot Surface Indicator Light
On ceramic glass models, the Hot Surface indicator light is located
on the console panel.
The Hot Surface indicator light will glow as long as any surface
cooking area is too hot to touch, even after the surface cooking
area is turned off.
WARNING
Fire Hazard
Turn off all controls when done cooking.
Failure to do so can result in death or fire.
Off
REMEMBER:
When range is in use, the entire cooktop area
may become hot.
A
B
C
A. Surface cooking area
B. Cookware/canner
C
1
/
2
" (1.3 cm) maximum overhang
COOKTOP
