8
INSTALLATION
INSTALLATION
Mount the Headrail
■
Tilt the headrail so that its back lip slides under
the front lip of the end brackets and intermediate
bracket(s).
■
Push the headrail against the back of the end
brackets.
■
Check that the front lip of the intermediate bracket(s)
is under the front lip of the headrail.
Adjust the Headrail Tightness
■
If the headrail is loose in the end brackets, bend the tabs on the end bracket outward.
NOTE:
The tabs may also be bent inward if the headrail is difficult to install into the end brackets.
■
If your headrail end brackets do not have adjustable tabs, bend the tabs on the headrail end locks to
adjust headrail tightness.
Close the End Brackets
■
Push the cover down until it snaps over the locking tab on the bottom of the end bracket.
Open the End Brackets (If Necessary)
■
To open the end brackets, insert a flat blade screwdriver between the bottom of the cover and the quick
release tab, and twist.
➤
You can also push up on the bottom of the end bracket to release the locking tab.
STEP 4 — Connect the Power Source, If Applicable
Refer to the appropriate page based on your order.
➤
For a headrail-mounted rechargeable battery wand, see”Testing the Blind” on page 11.
➤
For a battery wand, see”Testing the Blind” on page 11.
➤
For an optional rechargeable battery wand, see page 9.
➤
For an optional 18V DC Power Supply, see page 10.
➤
For an optional 18V DC Power Supply with daisy-chain connections, see page 10.
➤
For any other Kirsch
®
power supplies, see applicable instructions.
End Bracket
Intermediate Bracket
1
3
∕
8
"
Slat Size
1
3
∕
8
"
Slat Size
