13
14
button.
Battery Power Indication
When you press the button set as
Battery Power Indication
,
indication tone
1
,
2
,
3
or
4
sounds to indicate the
current battery power.
Temporary Activation of Channel Annunciation
When you press the button set as
Temporary Activation of
Channel Annunciation
, one of the following situation occurs:
a. If the current channel number sounds at the beginning:
Press the button set as
Temporary Activation of Channel
Annunciation
to sound two beeps to temporarily cancel the
channel annunciation function; you still can hear the channel
number annunciation after turning on the radio again.
b. If the current channel number doesn't sound at the beginning:
Press the button set as
Temporary Activation of Channel
Annunciation
to sound one beep to temporarily activate the
channel annunciation function; you won't hear the channel number
annunciation after turning on the radio again.
Activation of Channel Annunciation
When you press the button set as
Activation of Channel
Annunciation
, if the radio sounds two beeps, it cancels the
channel annunciation function; you won't hear the channel number
annunciation after turning on the radio again.
When you press the button set as
Activation of Channel
Annunciation
, if the radio sounds one beep, it activates the
channel annunciation function; you can hear the channel number
annunciation even after turning on the radio again.
Reverse Frequency
Press the button set as
Reverse Frequency
to activate the
reverse frequency function.
Wired Cloning Mode
If the wired cloning mode has been set, the radio won't exit
automatically after it entering the wired cloning mode. To return to the
user mode, you need to turn on the radio again.
Wired cloning procedures are as follows:
1) Press and hold the Side Button 2 on the host radio while turning
on the radio; about 2 seconds later, two short beeps sound and red
indicator flashes, and the radio enters cloning mode.
2) Press once the PTT button on the host radio, and then the sub
radio to receive data will enter the Activation/Prohibition of Wired
Cloning Mode. However, the wired cloning setting on the host radio
won't be changed.
After pressing the PTT button, if the green indicator flashes twice and
one beep sounds, it indicates the sub radio is in the state of
Activation of Wired Cloning; if the red indicator flashes twice and two
beeps sound, it indicates the radio is in the state of Prohibition of
Wired Cloning.
3) In the cloning mode, press the Side Button 2 on the host radio,
and then red indicator flashes and it begins cloning. After cloning, the
indicator turns dim.
Note:
You can activate or prohibit the wired cloning mode by PC
programming software. If the wired cloning mode is prohibited the
radio cannot enter the wired cloning mode.