Kirby Morgan Dive Systems, Inc.
®
1430 Jason Way Santa Maria, California 93455
Phone: 805/928-7772 Fax: 805/928-0342
www.KirbyMorgan.com email: [email protected]
KI
RBY
MORGA
N
D
IV
E SYSTEMS, I
nc
.
© MMXVII Kirby Morgan Dive Systems, Inc. All Rights Reserved Document # 170525006
Page 1 of 8
Part #525-757
SuperFlow
®
450 Regulator Parts Upgrade Kit
Part Number
Description
Qty
205-020
Inlet valve Assembly
1
210-055
O-ring
2
505-088
Adjustment Knob/Packing Nut Assembly
1
550-549
Balance Spacer
1
550-643
Transfer Pin
1
540-531
Lock Clip
1
NOTE: The upgrade kit assembly procedures are illustrated with the Regulator Body being shown removed
from the helmet. This is done only to emphasize and clarify the procedure. The Regulator Body can remain
in place (attached to the helmet) when completing the upgrade. THERE IS NO NEED TO REMOVE THE
REGULATOR BODY FROM THE HELMET to complete the following upgrade.
B
CAUTION
Use only KMDSI original replacement parts. The use of other manufacturers' parts will inter-
fere with the performance characteristics of your life support equipment and may jeopardize
your safety. Additionally, any substitutions will void any warranties offered by KMDSI. When
ordering spares, always insist on Kirby Morgan Genuine Parts.
Tools Required:
Torque Screwdriver
Flat blade screwdriver attachment
1/4
"
Torque wrench
Open end attachments
7/8
",
11/16
", 1",
15/16
"
Open end wrench
7/8
"
Christo-Lube
®
or equivalent.
Adjustment Flex Knob Removal
1. Remove the Bent Tube Assembly from the helmet, per "1.3.1 Removal of the Bent Tube Assembly" on
2. Using a
7/8
" wrench, remove the Bent Tube Adapter and O-ring.
