FP 25/50 E / FP 25/50 D / FP 10/50 A
Repair and Adjustments
Issue: 06/2011
87
6 .4 .15 Changing the Reflector
X
NOTE
Z
The reflector should only be changed by the projectionist in case of need.
At the next opportunity the reflector should be adjusted finely by service personnel
who has the necessary alignment tool.
Z
At normal case the reflector should be changed and adjusted by service personnel.
Z
The following chapter describes how the reflector can be changed in case of need.
Xenon bulb
Reflector
Bulb support (only big lamphouses)
Anode connecting bolt
Adjusting/fixing screws
Counterscrew
Handle star
DANGER
Observe the safety instructions, when opening the lamphouse.
- Switch off the projector.
- Wear protective clothes.
- Open the lamphouse only after waiting period of at least 10 minutes.
Removing the Reflector
• Remove the lamphouse door.
• Remove the xenon bulb.
• Loosen the upper holder rod by turning the handle star
.
• Carefully take out the reflector by tilting it forwards while the upper holder bar is
moved upwards.
• At this opportunity clean lamphouse by blowing compressed air in the lamphouse and
finally remove the dust with a vacuum cleaner.
2
1
3
4
5
5
6
7
Summary of Contents for FP 25 E PREMIERE
